VOC AS SUPPLIED:
Less than or equal to 4.50 lbs./gallon
Less than or equal 540 grams/liter

COLOR: All standard colors. Special
colors available upon request.

SOLIDS CONTENT:
37% + 2% by Volume

NUMBER OF COMPONENTS: One

SUGGESTED FILM THICKNESS: 1½-2½ mils DFT

THEORETICAL COVERAGE:
590 sq. ft. per mil per gallon

APPLICATION: Spray

APPLICATION TEMPERATURE:
40°F to 100°F

DRY TIME:
At 77oF, 50% relative humidity:
Dust free: Less than 1 hour
To handle: 2 - 3 hours
Print free: 6 - 10 hours

REDUCTION: Not generally required for most spray applications. If atomization of the material is not quite adequate, then the use of small amounts of R75 is recommended.

PACKAGING: 5-gallon pails and 55-gallon drums

SHELF LIFE: 12 months when stored between 40oF and 90oF

 

 

 

PCS-10270
ACRYLIC MODIFIED,
AIR DRY ALKYD ENAMEL

DESCRIPTION:  PCS-10270 is an acrylic modified alkyd enamel.  The acrylic modification of the coating improves the gloss and color retention properties for improved exterior durability and service life.

A HAP(s) (Hazardous Air Pollutants) free version of this product, PCS-10275, is available.  While both products offer the same physical characteristics and durability, PCS-10270 offers an economical advantage over the HAP(s) free version.  While these coatings are not VOC compliant, they still find use due to their fast dry and early resistance characteristics to exterior exposure.

USES:  OEM, implement finishes, general metals finishing, dumpsters and refuse equipment, and structural steel.

SURFACE PREPARATION:  As with all coatings, the better the surface preparation, the more protection the coating can offer. At a minimum, we suggest solvent wiping the parts to remove any oils and grease present on the surface.  If a primer is desired, PCS-13195 Corrosion Inhibitive Industrial Primer is recommended.

APPLICATION:  May be applied by air-assisted airless, HVLP, or conventional spray equipment.  For better transfer efficiency, the use of electrostatic spray equipment is suggested.

PCS-10270 was not designed to be applied by brush or roll application; however, this method of application may be suitable for touch-up.

CLEAN UP:  Clean up immediately after use with Xylene, lacquer thinner, or any of the Ketone family of solvents.

CAUTIONS:  Flammable mixture.  Contains solvents.   Keep away from heat, sparks, and flame.  Use only with adequate ventilation.  AVOID PROLONGED BREATHING OF VAPORS.  AVOID PROLONGED OR REPEATED CONTACT WITH SKIN.  Keep containers closed when not in use.  If used in confined areas, observe the following precautions to prevent hazards of fire or explosions or damage to health: (1) circulate adequate fresh air continuously during application and drying; (2) use fresh air masks and explosion-proof equipment; (3) prohibit all flames, sparks, welding, and smoking near area.

If swallowed, do not induce vomiting.  Call a physician immediately.  For eye contact, flush with lots of water.  In case of skin contact, wash thoroughly with soap and water.

See material safety data sheets for full precautions prior to use.

PCS-10270 is intended for INDUSTRIAL USE ONLY.

Manufacturing and Executive Offices:
5239 BRER RABBIT ROAD • STONE MOUNTAIN (ATLANTA), GEORGIA 30083-1317
Phone: (404) 292-4842                                                     Fax: (404) 296-4825