COLOR: Black

VOLUME SOLIDS: 27% + 3

VOC AS SUPPLIED: As supplied:
Excluding water: 2.6 +0.2 lbs./gallon
Including water: 1.0 +0.2 lbs./gallon

THEORETICAL COVERAGE: 430 sq. ft per mil per gal. (unreduced)

THINNING: None required for brush or roll; or airless spray

GLOSS: 90o +

SUGGESTED FILM THICKNESS:
1.0-1.5 mils DFT over primer
2.0-2.5 mils DFT direct to metal

APPLICATION: Roll, brush, or spray

APPLICATION TEMPERATURE:
40oF to 120oF

DRY TIME: At 77oF, 50% relative humidity: Dust free: 20 minutes
To handle: 1-3 hours
Recoat: 10-15 minutes

SERVICE TEMPERATURE:
140° F for continuous service
180° F intermittent

PACKAGING: 5-gallon pails,
55-gallon drums, and totes

SHELF LIFE: 3-6 months in unopened
containers when stored between 40oF
min. and 100oF max.



PCS-2250 HYDRO-TECH
WATER REDUCIBLE PIPE ENAMEL
ASPHALT MODIFIED

DESCRIPTION: An asphalt modified water-reducible enamel for interior or exterior use, has good color and gloss retention, and the ability to be applied either direct to metal or to previously-painted surfaces.

ADVANTAGES: PCS-2250 is extremely fast drying for a water reducible enamel, exhibiting very good early water resistance. It is V.O.C. compliant and has no flash point, which reduces fire hazards and may lower insurance costs.

USES: PCS-2250 is used to coat machinery, implements, sanitation equipment, pipe, pipelines, shipping containers, structural steel and as a general maintenance finish. Not recommended for interior pipe linings. Consult Permite for recommendations.

SURFACE PREPARATION: Remove all loose rust, loose paint, oil, grease or other interference materials prior to painting.

MIXING: Stir thoroughly before use.

THINNING: PCS-2250 will appear heavy bodied in comparison with solvent based paints, especially in colder temperatures. However, do not thin unless necessary to achieve atomization and then do so sparingly--no more than ½ pint of water per gallon.

CAUTIONS: PCS-2250 is not flammable. Components of this product may be skin irritants and/or skin sensitizers. Rubber gloves should be worn to minimize skin contact. Avoid breathing vapors of material. If swallowed, do not induce vomiting. Call a physician immediately. For eye contact, flush with lots of water. In case of skin contact, wash thoroughly with soap and water.

See material safety data sheets for full precautions prior to use.

 



PCS-2250 is intended for INDUSTRIAL USE ONLY.

Manufacturing and Executive Offices:
5239 BRER RABBIT ROAD • STONE MOUNTAIN (ATLANTA), GEORGIA 30083-1317
Phone: (404) 292-4842                                                     Fax: (404) 296-4825